Very nice. When you get to it, add some dimensions.Lampy wrote:The only one I have at the minute from before welding
3 Point Linkage Pallet Forks
Re: 3 Point Linkage Pallet Forks
1950 Tea 2080, 1951 Tea 2085



Re: 3 Point Linkage Pallet Forks
Overall width: 1000mm
T bar: 800mm
Angle braces: 600mm on top edge.
Re: 3 Point Linkage Pallet Forks
Thanks for all the comments! 
I’ve been a bit distracted faffing around with splitting my TED20 and doing some cosmetic tidying up but I’ve finally got it all back together and running again. Plenty more tidying up to do but from here on, hopefully it will be more of a “rolling restoration”!
Anyway, I finally got myself a set of pallet forks (option 3 from my original post), not the cheapest but the quality looks good and the manufacturer is not too far away (as opposed to China) so if there are any issues, I can get them resolved. Not carried anything serious yet but just played around with an empty pallet. I am mindful of the limitations of using these with a TE20 but think these will get a lot of use out of these!

I’ve been a bit distracted faffing around with splitting my TED20 and doing some cosmetic tidying up but I’ve finally got it all back together and running again. Plenty more tidying up to do but from here on, hopefully it will be more of a “rolling restoration”!
Anyway, I finally got myself a set of pallet forks (option 3 from my original post), not the cheapest but the quality looks good and the manufacturer is not too far away (as opposed to China) so if there are any issues, I can get them resolved. Not carried anything serious yet but just played around with an empty pallet. I am mindful of the limitations of using these with a TE20 but think these will get a lot of use out of these!
Re: 3 Point Linkage Pallet Forks
Definitely a Cat 1 linkage! 

Re: 3 Point Linkage Pallet Forks
Glad he didn't get squashed , that would have been ' Catastrophic ' 

-------- 1952 TED, 1957 FE35 Grey and Gold Deluxe