The Greyfergie Forum

With the ignition on but the engine not started a 3 ohm coil will draw about 4 amps. That's assuming that the contact breaker happens to be in the clo…login to view the rest of this post

[Local Link Removed for Guests] wrote: [Local Link Removed for Guests]Thu Oct 17, 2024 8:54 am

I think this is a case of back to Plan B. Trouble is,

…login to view the rest of this post

This has been maddening me for 38 years, and I have finally got round to fixing them. :)

The problem is that they were both very loose, but at the same…login to view the rest of this post

Is the shelter on skids, or just wooden timbers?
On a proper metal frame it should be easy. If on wooden skids then obviously you have to identify whic…login to view the rest of this post

I've got two wicked alternative suggestions;

A swivelling or partly swivelling seat,
or an idea I saw in Ireland once: A man was standing on the left-h…login to view the rest of this post

The tyre is about a year old, as is the tube.
The gauge was not sticking. The needle fell after each time I removed the gauge and then pressed the pres…login to view the rest of this post

One of my rear tyres has a very slow puncture. It's not worth the trouble of finding it, so I just pump it up every few months. It's hard work with a …login to view the rest of this post

I'm not sure it's a good idea to rely too much on tightening the bolt to eliminate up and down play , by squeezing the ends of the yoke closer togethe…login to view the rest of this post

I've just been out to look at mine. I can see that the belt might foul the bolt if kept in its normal orientation - it is quite wide.
But surely you t…login to view the rest of this post

It's funny the way wildlife will often ignore someone on a noisy tractor but run off if one is on foot. It's like pheasants in our garden. They seem u…login to view the rest of this post